When measuring product ensure to accommodate for an 1/8" (3mm) gap around the perimeter with the window to allow for installation They hired a local tint contractor to install and an electrician to connect the wires to the wall mounted swap.

Smart Tint™is completely customizable. The SMART CLING™ self adhesive Visit Website back again means that you can simply peel and stick the film on any smooth glass surface.

Step one.two: be certain that the adhesive aspect is experiencing up. Do not get rid of the protecting layer until you might be instructed in this technique to do so. The adhesive aspect is normally marked by using a label or even a purple stamp.

Our Smart Glass are customized cut, prewired and ready to install regardless of the measurement. We trim holes right into our privacy glass to accommodate any components desired.

Wires are soldered on to possibly end of each and every Bus bar. They may be twin (or twin) wires. This clear ‘double-up’ will be to compensate in the situation of a wire becoming detached or dislodged in the course of the panel’s installation course of action. The busbar may very well be placed on the very long or shorter edge/s, based upon your specifications.

placed on clear nitrile protective gloves and utilizing the edge tab of your label clear away the 1st 100mm(four″) of your protecting liner masking the cling side. Be certain that dust won't tumble on to the cling Sid

to eliminate air bubbles through film software, use a squeegee to gently push the film onto the floor, slowly Functioning outwards from the middle. Lift the afflicted area if stubborn bubbles persist and reapply, smoothing it out as you go.

-Inspect the Smart Cling Self adhesive area on the film for almost any burs or lifted edges to the side that could be hooked up for the glass only and take away if needed.

thorough Film managing: to forestall delamination, it’s crucial to tackle the film edges with treatment. Never fold, bend, or curve smart film. make sure the film is retained flat and straight as demonstrated underneath.

-get rid of the protective coating in the contact facet of the material before installation of your Non-Adhesive film and clean up the actual Smart Tint plus the glass with ninety nine% isopropyl alcohol only.

The protective liner over the adhesive facet really should only be peeled away following the Smart FIlm® has been placed on the glass and all air bubbles are already pressed absent using a squeegee.

we've been the one organization registered with the United States Patent and Trademark Office. All of our Smart products and solutions are manufactured listed here in America, permitting us to provide you with our sector major 5 calendar year guarantee, fastest turn-all around times and practically no production limitations.

Dim it, venture on it, stick it, hold it, use it being a whiteboard or significant-tech window treatment, and much more! Smart Film® switchable electrical films are intended to variably adjust The sunshine between a transparent and an opaque condition with AC ability.

prevent chemical cleaners: stay away from working with any substances or abrasive cleaners within the smart film surface and glass surface, resulting from They might corrode the PDLC film. We recommend working with either anhydrous Liquor or ninety nine% Isopropyl Alcohol along with a lint-cost-free fabric to scrub the glass surface..